MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
2. Press the mounting rubber until the mounting rubber end comes out completely from the gear housing using the SSTs and a press.
3. Reverse the gear housing, then press the mounting rubber until the mounting rubber end comes out completely from the other side. At this time,
mounting rubber end and steel pipe are aligned.
Tie-rod End Boot Assembly Note
1. Wipe the grease off the ball joint.
2. Put a small amount of lithium-based grease into a new dust boot.
3. Install the dust boot onto the tie-rod end using the SST and a press.
4. Wipe away any excessive grease.
Bushing Assembly Note
1. Align A and B and press a new bushing into the gear housing using the SST until the bushing is fully seated.