MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
Stabilizer Bar: Service and Repair
Front
FRONT STABILIZER REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Stabilizer Bushing Installation Note
1. Align the bushing with the positioning bushing on the stabilizer.
STABILIZER CONTROL LINK INSPECTION
1. Remove the stabilizer control link from the vehicle.
2. Inspect for bending and damage.