MX-6 L4-2184cc 2.2L SOHC F2 (1988)
Power Door Lock Switch: All Technical Service Bulletins
Power Locks - Drivers Lock Won't Lock/Unlock Other Doors
Bulletin No.: 018/91
Issued: 11/22/91
Revised:
Subject: POWER DOOR LOCKS MALFUNCTION
Applicable Model/s: 1988-'91 626/MX-6
Category: S
DESCRIPTION
A driver's side door lock that does not lock or unlock the remaining doors may have a damaged circuit in the door lock switch.
Modified switches have been installed in production vehicles starting June 3, 1991 (Hofu production) and June 25, 1991 (Flat Rock production). These
modified switches are not interchangeable with switches on vehicles produced prior to June 3rd and June 25th respectively.
Vehicles produced prior to June 3rd and June 25th that experience this driver door lock problem, should have switches replaced with the original switch.
The replacement switch must be water-proofed to prevent problem reoccurrence. See Repair Procedure for instructions.
VIN OF PRODUCTION CHANGE
Japan Made - 626/MX-6
JM1GD****M1917355
June 3, 1991
USA Made - 626
1YVGD22B8M5186161
June 25, 1991
REPAIR PROCEDURE
1.
Inspect switch. See Section 14 or S of the Workshop Manual.
2.
If necessary, replace the driver's door lock switch. See Workshop Manual for replacement procedures. Figure 1.
NOTE:
The modified parts are not interchangeable with the original parts. Refer to the VIN and Parts Information for correct model-to-parts
application.
