MX-6 V6-2496cc 2.5L DOHC (1996)
Overdrive Indicator Lamp: Testing and Inspection
O/D OFF INDICATOR LIGHT
Inspection Of Operation
1. Turn the ignition switch from OFF to ON.
NOTE: The O/D OFF indicator light will flash if a malfunction exists in any of the EC-AT system components.
O/D OFF Indicator Light/Switch
2. Verify that the O/D OFF indicator light is not illuminated.
3. Depress the switch and verify that the O/D OFF indicator illuminates.
4. If the O/D OFF switch function is not as specified, after checking the O/D OFF switch, check the terminal voltage of the 0/D OFF indicator light.
Inspection Of Voltage
1. Remove the instrument cluster.
2. Turn the ignition switch to ON.
Measure Voltage Between Terminal 2G And Ground
3. Measure voltage between terminal 2G and a ground.
Inspection Of Continuity
1. Disconnect the negative battery cable.
2. Disconnect the instrument cluster connector.
Inspection Of Continuity
