MX-6 LS V6-2.5L DOHC (1997)
Ignition Coil: Testing and Inspection
Inspection
Primary coil winding
FS [MTX], KL
1. Disconnect the 3-pin connector from the distributor.
2. Use an ohmmeter to measure resistance of the primary coil winding.
Specification: 0.49-0.73 ohm [at 20 °C {68 °F}]
3. If not within the specification, replace the distributor.
FS [ATX]
1. Disconnect the ignition coil connector from the ignition coil.
2. Use an ohmmeter to measure resistance of the primary coil winding.
Specification: Approx. 0.4 ohm [at 20 °C {68 °F}]
3. If not as specified, replace the ignition coil.
Secondary coil winding
FS [MTX], KL
1. Disconnect the 3-pin connector from the distributor.
2. Remove the distributor cap.