Navajo 2WD V6-4.0L OHV (1992)
Alignment: Technical Service Bulletins
Alignment - Background Information & Specifications
Bulletin No.: 003/94
Issued: 12/23/94
Revised:
Category
N
Applicable Model/s
All Models
Subject:
ALIGNMENT SPECIFICATIONS
DESCRIPTION
This bulletin provides background information on standard specification and measuring conditions for wheel alignment.
Measured values are not absolute. Variations occur between technician, equipment and the condition of the vehicle at the time of measurement. To avoid
unnecessary adjustments, specifications and measurement conditions have been changed in the workshop manual. These changes are described below.
NOTE:
Changes in the specifications do not imply that alignment tolerances have increased during production. Vehicle alignment is set to the median
specifications during production and technicians should also use median specifications during alignment adjustment.
New Specifications
New Specifications
VEHICLE PREPARATION AND CONDITION
1.
The vehicle should have:
^
No Passengers
^
No Luggage
^
Gas Tank Full, Radiator and Engine Oil To The Specified Levels
^
Spare Tire, Jack And Tools Stored In Designated Areas
^
Tire Pressure Checked And, If Necessary, Adjusted.
NOTE:
If the specifications are different (depending on load conditions). adjust the pressure for the lightest load.
