Navajo 2WD V6-4.0L OHV (1992)
4.
Clean and inspect the O/D one-way clutch outer race (part of center shaft) and the inner race (part of O/D planet carrier). Replace as necessary.
INSTALLATION PROCEDURES
1.
Install the steel caged one-way clutch into the center shaft with the round edge facing toward the bottom of the center shaft and the shoulder edge
facing out. Refer to Fig. 3
2.
Install the retaining washer into the O/D ring gear with the stamped tabs facing in. See Fig. 4.
NOTE:
The ring gear is machined to accept a retaining washer.