mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Retractor Switch - Seat Belt Lamp/Buzzer ON|Page 4483 > < Retractor Switch - Seat Belt Lamp/Buzzer ON|Page 4481
Page 3
background image

A cracking noise which sounds like metal contacting other metal may be heard around the "B" and "C" pillar while driving. This is caused by the door
lock striker installation bolts vibrating against the body panel. Refer to Fig. 1. If a customer complains of this noise, adjust the door lock striker nut plate
to prevent contact.

REPAIR PROCEDURE

1)

Verify complaint.

2)

Loosen the door lock striker bolts. Refer to Fig. 2.

3)

Center the door lock striker holes with the holes in the nut plate.

NOTE:

Be sure the nut plate holes are aligned to prevent contact with the body panel.

4)

Verify that the striker is aligned and tighten the door lock striker bolts.

Tightening Torque: 1.8 - 2.7 kgfm

5)

Verify repair.

WARRANTY INFORMATION

(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term
Information)

Warranty Type:

A

Symptom Code:

82

Retractor Switch - Seat Belt Lamp/Buzzer ON|Page 4483 > < Retractor Switch - Seat Belt Lamp/Buzzer ON|Page 4481