Protege L4-1839cc 1.8L DOHC (1990)
Camshaft pulley
1. Hold the camshaft with a wrench at hexagonal portion.
2. Remove the camshaft pulley lock bolt.
3. Remove the camshaft pulley.
Camshaft
1. Loosen the camshaft cap bolts in two or three steps in the order shown in the image.
2. Remove the camshaft caps.
3. Remove the camshaft.
4. Remove the camshaft oil seal from the camshaft.
Installation note
Camshaft
Note
^
The intake camshaft is grooved for the distributor drive.
1. Apply clean engine oil to the camshaft journals and bearings.
2. Install the camshaft in position.
Caution
^
Do not allow any sealant on the camshaft journal surfaces.
3. Apply silicone sealant to the shaded areas shown in the image.