Protege L4-1839cc 1.8L DOHC (1990)
1. Remove the front wheel hub component by using the SSTs.
2. If the bearing inner race remains on the front wheel hub component, grind a section of the bearing inner race until approximately 0.5 mm (0.02
inch) remains. Then remove it by using a chisel.
Wheel Bearing Removal Note
-
Press out the wheel bearing by using the SSTs.
Dust Cover Removal Note
NOTE: The dust cover does not need to be removed unless replacing it.
1. Mark the dust cover and steering knuckle for proper assembly.
2. Remove the dust cover by using a chisel.
Hub Bolt Removal Note
NOTE: The hub bolts do not need to be removed unless replacing them.