Protege L4-1839cc 1.8L DOHC (1990)
Valve Body: Service and Repair
Main Control Valve Body
MAIN CONTROL VALVE BODY
Disassembly / Inspection / Assembly
Caution:
^
Each valve should slide out/in under its own weight.
^
When a valve will not slide out under its own weight, depending on the valve, push it out with a wire or place the valve body open-side
down and lightly tap it with a plastic hammer. Never scratch or otherwise damage a valve surface or bore.
^
Do not drop or lose the valves or internal parts.
^
Before assembly, make sure all parts are thoroughly clean.
^
Apply ATF to all parts and bores.
^
Do not reuse any part that has been dropped.
^
Wrap a screwdriver or rod with tape before using it to insert a valve.
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly, referring to Assembly procedure.
