Protege L4-1839cc 1.8L DOHC (1990)
Snap Ring and Tripod Joint (4, 5)
1. Mark the shaft, tripod joint, and free rings for proper reassembly.
2. Remove the snap ring by using snap-ring pliers.
3. Remove the tripod joint from the shaft by using a bar and a hammer.
Boot (7)
NOTE: The wheel-side boot does not need to be removed unless you are replacing it.
Wrap the splines of the shaft with tape to prevent damaging the boot.
Dynamic Damper (6)
1. Install the dynamic damper as shown in the illustration. Length should be within 292 - 298 mm (11.5 - 11.7 inch).
2. Install the new boot band onto the dynamic damper. Standard length is 292 - 298 mm (11.5 - 11.7 inch).
Boot (7)
NOTE: Observe different markings on the wheel side and differential-side boots respectively for installation.
1. Wrap the splines of the differential-side shaft, and install the wheel-side and differential-side boots.