Protege L4-1839cc 1.8L DOHC (1990)
3. Release any trapped air from inside the boot by using a rag-covered screwdriver.
4. Verify that the drive shaft length is within the standard.
5. If the drive shaft length is not within the standard, return to step 1.
6. Fold the new bands back by pulling on the ends with pliers, so that the ends of the bands are pointing opposite the forward revolving
direction of the shaft.
7. Lock the ends of the bands by bending the locking clips.
Removal
Axle Shaft Assembly
1. Remove wheel and tire (1).