Protege L4-2.0L DOHC (2003)
Trunk / Liftgate Latch: Service and Repair
TRUNK LID LOCK REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order indicated below.
1. Cover
2. Connector
3. Trunk lid lock
4. Trunk lid lock cylinder
5. Internal trunk lid release handle (See Internal Trunk Lid Release Handle Installation Note.)
6. Rod
3. Install in the reverse order of removal.
Internal Trunk Lid Release Handle Installation Note
CAUTION: Always keep the handle firmly attached to the holder and in the recessed position. Not securing the handle this way could allow it to snag
luggage in the compartment and open the trunk lid.
1. After installation of the internal trunk lid release handle, pull the handle forward to verify the handle and rod are securely installed.
2. Attach the handle to the holder and in the recessed position.