Protege L4-2.0L DOHC (2003)
a. Make sure the valves moves smoothly.
b. Move the lever by hand to firmly close the valve. With the valve closed, move the lever toward the shaft back and forth and make sure the shaft
and valves move together.
CAUTION: If they do not move together, there is a possibility that a valve is touching the port. Loosen the screws until valves are just free to move,
and then re-adjust the location of each valve according to the Step 2 "If looseness is observed in the valve and shaft".
4. Reinstall the parts in the reverse order of the removal.
5. Make sure each part is installed in the correct position and functions properly according to the Workshop
Manual.
6. Reinstall fuel pump relay into main fuse box.
7. Start engine and check for leaks in the fuel system.
C. CAMPAIGN LABEL INSTALLATION
Complete a "Campaign Label" with the RECALL number written on the sticker and affix it to the vehicle's hood or bulkhead. Refer back to the
illustration under "A. VEHICLE INSPECTION PROCEDURE".
