Protege L4-2.0L DOHC (2003)
6. Working with another person, saw through the sealant around the edge of the glass, being careful to not damage the vehicle body.
NOTE: Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
7. Pull the quarter window glass, then disengage the fastener, pin and clip.
8. Remove the fastener and pin from the body.
QUARTER WINDOW GLASS INSTALLATION
CAUTION: To prevent the sealant from cracking or the glass from being pushed out by air pressure if a door is closed, open all of the windows and
leave them open until the sealant has hardened.
1. Cut away the old sealant using a razor so that 1 - 2 mm {0.04 - 0.07 in} thickness of sealant remains around the circumference of the frame.
-
If all the sealant has come off in any one place, apply some primer after degreasing, and allow it 30 minutes to dry. Then put on new sealant to
create 2 mm {0.08 in} layer.
WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
2. Clean and degrease the ceramic part of the glass and around the circumference of the bonding area on the body.
