Protege DX L4-1.6L DOHC (2000)
15. Start the engine and
1. Inspect the pulleys and drive belt for runout and contact.
2. Inspect the ignition timing. See: Tune-up and Engine Performance Checks/Ignition Timing
3. Inspect the idle speed. See: Tune-up and Engine Performance Checks/Idle Speed
Camshaft Pulley Removal Note
1. Temporarily install the No.3 engine mount.
2. Remove the SST (engine support).
3. Hold the camshaft using a wrench on the cast hexagon as shown.
Camshaft Removal Note
1. Loosen the camshaft cap bolts a few turns in the order shown.
2. Remove the camshaft cap.
Cylinder Head Removal Note
1. Loosen the cylinder head bolts a few turns in the order shown.
Cylinder Head Installation Note
1. Measure the length of each bolt.