Protege DX L4-1.6L DOHC (2000)
Assembly procedure
1. Insert the bypass spring, bypass valve, and stop plug. Secure them with the stop pin.
2. Insert the 2-3 shift spring, 2-3 shift valve, and plug. Secure them with the stop pin.
3. Insert the converter relief valve and converter relief spring. Secure them with the spring retainer.
4. Insert the torque converter clutch control spring, torque converter clutch control valve, and stop plug. Secure them with the stop pin.
Main Control Valve Body
MAIN CONTROL VALVE BODY
Disassembly / Inspection / Assembly
Caution:
^
Each valve should slide out/in under its own weight.
^
When a valve will not slide out under its own weight, depending on the valve, push it out with a wire or place the valve body open-side
down and lightly tap it with a plastic hammer. Never scratch or otherwise damage a valve surface or bore.
^
Do not drop or lose the valves or internal parts.
^
Before assembly, make sure all parts are thoroughly clean.
^
Apply ATF to all parts and bores.
^
Do not reuse any part that has been dropped.
^
Wrap a screwdriver or rod with tape before using it to insert a valve.
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly, referring to Assembly procedure.