mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Interior - Rubbing Noise While Driving|Page 4019 > < Interior - Console Damage Prevention During Removal
Page 1
background image

Console: All Technical Service Bulletins
Interior - Rubbing Noise While Driving

S020/98 

NOISE FROM FRONT CONSOLE

All 1997-98 Protege with VINs lower than JM1BC14**W0181336.

A rubbing noise is heard from the front console when driving. This is caused by the dash board and front console rubbing against each other. To prevent
this noise, felt pads have been added to the front console as shown.

Customers complaining of this concern should have their vehicles repaired using the following procedure.

1.

Verify customer complaint.

2.

Remove the front console according to the Workshop Manual section S (01).

CAUTION

The Workshop Manual does not mention two plastic tabs that must be released. Use a screwdriver to prevent breakage.

3.

Place adhesive foam pads in locations as shown.

NOTE:

If any other noise preventative padding is damaged or deformed during the removal process, replace it with new or similar material.

4.

Verify repair.

Interior - Rubbing Noise While Driving|Page 4019 > < Interior - Console Damage Prevention During Removal