Protege DX L4-1489cc 1.5L DOHC MFI (1998)
NOTE: The sensor rotor does not need to be removed unless replacing it.
-
Tap the ABS sensor rotor off of the drive shaft by using a chisel.
ABS Sensor Rotor Assembly Note
-
Set a new ABS sensor rotor on the drive shaft in the direction shown, and press it onto the shaft component by using the SST.
Dynamic Damper Assembly Note
1. Install the dynamic damper as shown in the image.
Length L
Z5 engine: 434 - 440 mm (17.1 - 17.3 inch)
Z5 engine (California): 292 - 298 mm (11.5 - 11.7 inch)
BP engine: 247 - 253 mm (9.73 - 9.96 inch)
2. Install the new boot band onto the dynamic damper.
Standard length
Z5 engine: 434 - 440 mm (17.1 - 17.3 inch)
Z5 engine (California), BP engine: 292 - 298 mm (11.5 - 11.7 inch)
Boot Assembly Note
NOTE: The initials TJ and BJ are stamped on the wheel side and differential side boots respectively.