Protege DX L4-2.0L DOHC (2002)
5. Push and release the secondary piston component to verify that it is held properly by the stop screw.
Stop Pin and O-ring (with ABS) Assembly Note
1. Install the secondary piston with the piston hole facing the stop pin and primary piston.
2. Install the new O-ring onto the stop pin.
3. Push the primary piston assembly in full.
4. Install and tighten the stop pin.
Tightening torque 6.87 - 9.80 Nm (70 - 100 kgf-cm, 60.8 - 86.7 inch lbs.)
5. Push and release the secondary piston component to verify that it is held properly by the stop pin.
