Protege DX L4-2.0L DOHC (2002)
3. From this position slide the lock unit to fix the lock unit hook into the bracket hole securely as shown in the figure.
4. Install the interlock cable to the key cylinder.
5. Slide the outer casing to the key cylinder. Verify that the outer casing hook is secured in the cylinder hole.
6. Insert the clip over the convex part of the outer casing.
Caution:
^
Allowing the interlock cable to become bent or twisted during installation can affect the lock unit operation.
7. Install the interlock cable end onto the cam pin on the selector lever.
8. Fit the interlock cable in the U-groove in the selector lever base plate, and install the clip.
Note:
^
Steps 9 - 12 are for the interlock cable replacement only.
Caution:
