Protege ES L4-1839cc 1.8L DOHC (1997)
Vehicle Speed Sensor: Service and Repair
REPLACEMENT
1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner component, and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor. Tighten to:
7.9 - 10.7 Nm (70 - 95 inch lbs.).
7. Connect the input/turbine speed sensor connector.
8. Install the battery carrier, air cleaner component, and battery.
9. Connect the negative battery cable.