Protege ES L4-2.0L DOHC (2001)
Brake Rotor/Disc: Testing and Inspection
Rear
REAR BRAKE (DISC) INSPECTION
Brake Judder Repair Hint
Refer to Brake Rotor/Disc; Testing and Inspection; Procedures; Front.
Disc Pad Thickness Inspection
1. Jack up the rear of the vehicle and support it on safety stands.
2. Remove the wheel and tires.
3. Look through the caliper inspection hole and inspect the remaining thickness of the pads.
-
Replace the pads as a set (right and left wheels) if either is less than the minimum thickness.
Minimum thickness 1.0 mm (0.039 inch)
Disc Plate Thickness Inspection
1. Measure the thickness of the disc plate.
-
If the thickness is not within the specification, replace the disc plate.
Caution: When it is necessary to machine the disc plate, and the disc plate Is removed from the vehicle then machined, excessive runout may
result. Machine the disc plate which is installed on the vehicle.
Minimum 8 mm (0.31 inch)
Minimum thickness after machining by using a brake lathe on-vehicle 8.8 mm (0.35 inch)