Protege LX L4-1.6L DOHC (2000)
CAUTION: Keep the area tree of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass and
body, which may cause leaks to occur.
12. Use a brush to apply primer to the bonding area of the glass, the body, and the molding within the region shown.
NOTE: Use only glass primer on the glass, and body primer on the body and the molding. Allow it to dry for approximately 30 minutes.
13. Once the primer is dry, apply sealant around the entire circumference to fill the gap between the dam and the edge of the glass measuring 11.0 mm
{0.433 in} high and 5.0 mm {0.20 in} wide.
14. Align the glass marks with the V-notches in spacers and install the glass onto the body.
15. Press firmly inward on the glass to compress the sealant.
16. Verify that the gap along the upper edge is 7.3 mm {0.29 in} and side edge is 6.8 mm {0.27 in}.