mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Front Console - Rubbing Noise|Page 4011 > < Interior - Rubbing Noise While Driving|Page 4006
Page 1
background image

Console: Customer Interest
Front Console - Rubbing Noise

Bulletin No. 020/98

Issued 08/05/98

Revised

Category
S (09)

Applicable Model/s
1997-98 Protege

Subject
NOISE FROM FRONT CONSOLE

APPLICABLE MODEL(S)/VINS
All 1997-98 Protege with VINs lower than JM1BC14**W0181336.

DESCRIPTION

A rubbing noise is heard from the front console when driving. This is caused by the dash board and front console rubbing against each other. To prevent
this noise, felt pads have been added to the front console as shown.

Customers complaining of this concern should have their vehicles repaired using the following procedure.

REPAIR PROCEDURE

1.

Verify customer complaint.

2.

Remove the front console according to the Workshop Manual section S (01).

Caution

^

The Workshop Manual does not mention two plastic tabs that must be released. Use a screwdriver to prevent breakage.

Front Console - Rubbing Noise|Page 4011 > < Interior - Rubbing Noise While Driving|Page 4006