mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Rear Suspension Tower - Thumping Noise|Page 4205 > < Spoilers, Flaps, and Air Dams|Service and Repair
Page 1
background image

Strut / Shock Tower: All Technical Service Bulletins
Rear Suspension Tower - Thumping Noise

Bulletin No. 002/98

Issued 07/29/98

Revised

Category
R (02)

Applicable Model/s
1997-98 Protege

Subject
THUMPING NOISE FROM REAR SUSPENSION TOWER

APPLICABLE MODEL(S)/VINS
All 1997-98 Protege with VINs lower than JM1 BC14*W0186598.

DESCRIPTION

When driving on a rough road, a thumping noise is heard from the rear left and/or right suspension tower. This is caused by the adjusting sheet allowing
the rear shock absorber and coil spring assembly to make contact with the body panel. A modified adjusting sheet is available to prevent this noise.
Customers complaining of this should have their vehicle repaired according to the following procedure.

REPAIR PROCEDURE

1.

Verify customer complaint.

2.

Remove the rear shock absorber and coil spring assembly. Refer to the Workshop Manual section R(02) for removal and installation procedures.

Rear Suspension Tower - Thumping Noise|Page 4205 > < Spoilers, Flaps, and Air Dams|Service and Repair