Protege LX L4-1489cc 1.5L DOHC MFI (1998)
-
Harness/pin clamp is loose or disconnected.
Investigate the GND system
1. Confirm that terminal sensor #5 is at 0 V.
(1) If it is at 0 V, inspect the sensor. If necessary, replace the sensor.
(2) If not, check the following points:
-
Open or short circuit in harness
-
Female terminal opening loose
-
Coupler (pin holder) damage
-
Pin discoloration (blackness) Harness/pin clamp is loose or disconnected.