Protege LX L4-1489cc 1.5L DOHC MFI (1998)
2. Mark the upper spring seat and coil spring for proper reassembly.
3. Align the marks of the upper spring seat and coil spring. Protect the upper spring seat and the coil spring with a piece of cloth, then assemble
the SSTs.
4. Use the SSTs to compress the spring.
5. Install the lower spring seat.
6. Install the bound stopper.
7. Install the dust cover.
8. Install the shock absorber, fitting the end of the coil into the step of the lower seat.
Piston Rod Nut Installation Note (10)
1. Tighten the nut several turns.
2. Remove the SST.
3. Verify that the lower coil of the spring is properly seated on the step of the lower seat.
CAUTION: To prevent damage to the rear shock absorber, use protective plates in the jaws of the vise.
4. Secure the rear shock absorber in a vise.
5. Tighten the nut.
Tightening torque: 55 - 67 Nm (41 - 49 ft. lbs.).
SHOCK ABSORBER INSPECTION
Inspect for the following and replace the shock absorber if necessary.
1. Inspect for damage and oil leakage.