Protege LX L4-2.0L DOHC (2001)
23.
When the TSB screen appears, press tick.
24.
Turn ignition OFF as indicated in the operator action screen appears, press tick.
25.
After PCM Reprogramming screen note appears
NOTE:
These actions are not necessary on the Protege'. Press tick.
26.
Select NO when the PAT screen appears.
27.
Turn ignition ON as indicated in the operator action screen.
28.
At this point the DOWN LOADING DATA screen appears and the reprogramming begins.
CAUTION:
The reprogramming process takes approximately 20-25 minutes, during this time take actions to assure that the vehicle ignition system or
WDS cables are not disturbed.
29.
Turn the ignition switch OFF when the operator action appears. Press tick.
30.
Turn the ignition switch ON when the operator action appears. Press tick.
31.
When operator action screen appears, press tick.
32.
Fill out the PCM reprogramming Label with data on this screen and place near the emission label on hood.
33.
Press tick and start the engine.