Protege LX L4-2.0L DOHC (2001)
4. Inspect for an open or short circuit in the following wiring harnesses by probing the applicable sensor and SST (104 Pin Breakout Box) terminals
with ohmmeter leads.
-
If there is an open or short circuit, repair or replace wiring harnesses.
-
If there is no open or short circuit, replace the clutch switch.
Open circuit
-
Signal circuit (Clutch switch connector terminal B and PCM connector terminal 6 through common connector)
-
GND circuit (Clutch switch connector terminal A and GND)
Short circuit
-
Signal circuit (Clutch switch connector terminal B and PCM connector terminal 6 through common connector to GND)
5. Install the clutch switch.