RX7 2RTR-1308cc 1.3L MFI (1991)
Locknut
Mark the ti~rod end locknut for reference during installation before loosening.
Tie-rod End Boot
Secure the tie-rod end in a vise. Piece a chisel against the looot and hold it at the angle shown. Remove the boat.
Caution: Do not scar the part where the boot attaches to the tie-rod end.
INSTALLATION
Tie-rod End Boot
Put a small amount of grease (lithium base) into the new boot and set it onto the tie-rod end. Install the boot onto the tie-rod end with the SST and
a press.
3. After installation, check the steering angle and t~in1 and adjust if necry. (Refer to Section R.)