RX7 2RTR-1308cc 1.3L MFI (1991)
1. Remove the exhaust pipe and heat insulator.
2. Remove the propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft
3. Remove the oil seal from the extension housing.
4. Apply transmission oil to outer periphery and lip surface.
5. Install the new oil seal with the SST.
6. Install the propeller shaft. See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft
7. Install the heat insulator and exhaust pipe.