RX7 2RTR-1308cc 80 (1984)
Child Restraint: Technical Service Bulletins
Child Restraint - Seat Locking Clip Needed to Install
Category 20
Applicable Model/s ALL MODELS
Subject
CHILD RESTRAINT SEAT LOCKING CLIP
Bulletin No. 001/84
Issued
11/19/84
Revised
DESCRIPTION
A seat belt locking clip is necessary to install a child restraint system in the front seat of a Mazda vehicle. Please advise customers to refer to the Owner's
Manual for installation instructions.
PARTS INFORMATION
PART NUMBER DESCRIPTION
FA55 57 999
Locking Clip
INSTALLATION PROCEDURE
1.
Fasten the lap and shoulder belts over the child restraint system.
2.
Tighten the lap belt by pulling on the shoulder belt.
3.
To install the locking clip, insert the lap and shoulder webbing through the recesses of the locking clip near the seat belt latch.
4.
If necessary, slide the seat forward to remove slack.
5.
After securing the belt by use of the locking clip, tuck the shoulder portion of the belt between the child restraint system and the seatback.
NOTE:
Store the locking clip in the glove box to prevent it from getting lost when the child restraint system is not in use.