RX7 2RTR- 1308cc 1.3L FI (1987)
Suspension Mode Switch: Testing and Inspection
Fig. 4 AAS switch component test
1.
Disconnect AAS control unit electrical connector, then place ignition switch in On position.
2.
With AAS switch in ``SPORT'' position, ensure 12 volts is present at terminal F and ground. If voltage is not as specified, check for defective AAS
switch or damaged or disconnected wire harness.
3.
Disconnect AAS switch electrical connector, then connect ohmmeter to terminals a and d, Fig. 4. If continuity is not present, replace AAS switch.