RX7 2RTR- 1308cc 1.3L FI (1987)
Wiper Motor: Testing and Inspection
Front
Wiper System Circuit Diagram
WIPER MOTOR CIRCUIT CHECK
Wiper Motor Circuit Check
1.
Unplug wiper motor electrical connector.
2.
With ignition switch "ON," measure voltage between wire at terminal "L" and a body ground. It should be approximately 12V.
3.
If there is no voltage, check fuse or repair wiring harness.
4.
With an ohmmeter, check that continuity exists between terminal "B" and ground. If not as specified, ensure that connectors and wiring are in good
condition. Repair problems as needed.
WIPER MOTOR TESTING