RX8 2RTR-1.3L (2006)
Throttle Body: Testing and Inspection
THROTTLE BODY INSPECTION
NOTE: Perform the following inspection only when directed.
Resistance Inspection
1. Remove the throttle body.
2. Verify that there is no continuity between the throttle body and throttle body each terminal using an ohmmeter.
-
If not as specified. replace the throttle body.
3. Measure the resistance between the throttle actuator terminals using an ohmmeter.
-
If not as specified, replace the throttle body.
-
If as specified, carry out the "Circuit Open/ Short Inspection".
Throttle Actuator Resistance
Throttle actuator resistance
Circuit Open/Short Inspection
1. Disconnect the PCM connector.