RX8 2RTR-1.3L (2006)
Trailing Arm: Service and Repair
Rear Trailing Link (Upper) Removal/Installation
REAR TRAILING LINK (UPPER) REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the rear wheel alignment.
Caliper Component Removal Note
1. Hang the caliper component by the cable and move aside.
Rear Trailing Link (Upper) Ball Joint Removal Note
1. Using the SST, disconnect the ball joint.
Note:
^
When removing the rear trailing link (upper) ball joint, the rear knuckle bushing may also come off. If it comes off, replace the rear knuckle.
Dust Boot Installation Note
1. Wipe the grease off the ball joint stud.
