Tribute 2WD L4-2.3L (2005)
4. Drill the holes as follows:
A. Holding the drilling guide securely in place, position the drill bit in either of the two (2) guide holes.
B. Start the drill motor and allow it to achieve full speed.
C. Drill the hole at a slow to moderate pace, occasionally pulling the bit out to clear the chips.
D. Drill the hole to the proper depth using the stop on the bit as your depth gauge.
E. Drill the second hole in the same foam block in the same manner.
F. Repeat steps A E on the foam block on the other side of the headliner.
5. Thoroughly clean all foam chips from the vehicle. Remove the covers from the instrument panel and make sure no chips remain in the vehicle.
Proceed to ASSEMBLY.
