Tribute 2WD L4-2.3L (2005)
2. Remove the accessory drive belt.
3. Remove the crankshaft pulley.
4. Remove the crankshaft front oil seal.
5. Remove the engine mount.
6. Remove the coolant pump pulley bolts and the coolant pump pulley.
7. Remove the two power steering pump bolts.
Note:
^
The bolt under the power steering pressure tube will remain with the power steering pump.
8. Remove the bolts and position the power steering pump aside.
9. Disconnect the crankshaft position (CKP) sensor electrical connector.
10. Remove the CKP sensor bolts and the CKP sensor.
Note:
^
Whenever the crankshaft position (CKP) sensor is removed, a new one must be installed, using the alignment jig supplied with the new part.
11. Remove and discard the CKP sensor.
