Tribute 2WD L4-2.3L (2005)
Daytime Running Lamp: Testing and Inspection
DAYTIME RUNNING LAMPS (DRL)
Inspection and Verification
NOTE: When installing a new smart junction box (SJB), it must be reconfigured for this feature if originally equipped. See MODULE
CONFIGURATION.
1. Verify the customer concern by operating the daytime running lamps (DRL) following these steps:
-
Place the ignition switch in the RUN position.
-
Place the headlamp switch in the OFF position.
-
Fully apply the brake.
-
Release the parking brake.
-
Place the transaxle in DRIVE.
-
If the DRL does not operate, make sure the SJB is configured for DRL before proceeding to the next step.
2. Verify the parking lamp operation.
-
Place the headlamp switch in the parking lamps ON position.
If the parking lamps do not operate correctly, see PARKING, REAR AND LICENSE LAMPS.
3. Verify the high beam operation.
-
Place the headlamp switch in the headlamps ON position.
-
Place the multifunction switch in the high beam position.
If the high beams operate correctly and the DRL operation is incorrect, INSTALL a new SJB. See SMART JUNCTION BOX (SJB). TEST
the system for normal operation.
If the high beams do not operate correctly. See HEADLAMPS in this section for correct diagnosis.
