Tribute 2WD L4-2.3L (2005)
Engine Control Module: Service and Repair
Removal and Installation
POWERTRAIN CONTROL MODULE (PCM)
Removal and Installation
NOTE: When the PCM is replaced, the new PCM must be programmed with the old module's configuration information. See POWERTRAIN
CONTROL MODULE (PCM) PROGRAMMING - WDS.
1. Disconnect the battery ground cable. See BATTERY DISCONNECT.
2. Remove the powertrain control module (PCM) cover.
-
Loosen the bolt and disconnect the electrical connector.
-
Remove the nuts and the cover.
3. Remove the PCM.
4. To install, reverse the removal procedure.