Tribute 2WD L4-2.3L (2005)
NOTE: Restraint system diagnostic tools MUST be installed under the seats in the side air bag and safety belt pretensioner (if equipped) to floor
connectors.
NOTE: Diagnostics or repairs are not to be performed on a side air bag system and/or a safety belt pretensioner (if equipped) system with the seats in
the vehicle. Prior to attempting to diagnose/repair the side air bag system and/or a safety belt pretensioner (if equipped) system the seats must be
removed from the vehicle and the restraint system diagnostic tools must be installed in the side air bag and the safety belt pretensioner (if equipped)
connectors at the floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.
NOTE: Diagnostics may be performed on seat systems other than the side air bag or the safety belt pretensioner (if equipped) system (lumbar, climate
controlled, heated power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the seats in the
side air bag and safety belt pretensioner to floor connectors.
NOTE: After diagnosing/repairing a seat system, the restraint system diagnostic tools must be removed before operating the vehicle over the road.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition install the original part and perform the diagnostic
procedure again.
1. Depower the system. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
2. Open the glove box past its stops.
3. Through the glove box opening toward the center of the instrument panel, disconnect the passenger air bag electrical connector.
1. Push to release the passenger air bag electrical connector. locking clip.
2. Disconnect the passenger air bag electrical connector.
4. Attach the air bag to the vehicle harness side of the passenger air bag electrical connector.
5. Remove the four passenger air bag bolts.
