Tribute 2WD L4-2.3L (2005)
Both rear safety belt retractors
16. Remove the rear safety belt retractor.
1. Using the special tool, remove the bolt.
2. Remove the rear safety belt retractor.
Installation
Both rear safety belt retractors
1. Install the rear safety belt retractor.
1. Position the rear safety belt retractor to the C-pillar.
2. Using the special tool, install the bolt.
LH side only
2. Position the rear quarter trim panel.
-
If equipped, connect the power point electrical connector.
Both retractors
NOTE: Make sure the safety belt webbing is not twisted prior to installation.