Tribute 2WD L4-2.5L (2009)
Trunk / Liftgate Latch: Service and Repair
Liftgate Glass Latch Removal/Installation
LIFTGATE GLASS LATCH REMOVAL/INSTALLATION
NOTE:Make sure the liftgate glass is in the raised position.
1. Remove the liftgate trim panel. See .
2. Disconnect the liftgate glass latch ajar switch electrical connector.
3. Remove the 2 bolts and the liftgate glass latch.
1
To install, tighten to 12 Nm {1.2 kgf-m, 106 in-lbf}.
NOTE:Mark the position of the liftgate glass latch prior to removing the liftgate glass latch bolts.
4. To install, reverse the removal procedure.
NOTE:The liftgate glass latch must be checked to make sure the latch is installed and aligned correctly.