Tribute 2WD L4-2.5L (2009)
Trim Panel: Service and Repair
B-Pillar Trim Panel Removal/Installation
B-PILLAR TRIM PANEL REMOVAL/INSTALLATION
Removal/Installation
Upper
1. Remove the safety belt D-ring guide cover by squeezing the height adjuster buttons and pulling the cover out at the bottom.
NOTE:Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
2. Remove the safety belt bolt.
-
To install, tighten to 48 Nm {4.8 kgf-m, 35 ft-lbf}.
3. Position the front and rear door weatherstrips aside.