Tribute 2WD L4-2.5L (2009)
5. Install the center safety belt anchor bolt.
-
Tighten to 35 Nm {3.5 kgf-m, 35 ft-lbf}.
RH Rear Seat Backrest
1. Install the center safety belt anchor bolt.
-
Tighten to 40 Nm {4.0 kgf-m, 30 ft-lbf}.
2. Route the safety belt buckles through the elastic straps.
3. Position both rear seat cushions in place.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
Rear Seat Backrest Cover Removal/Installation
REAR SEAT BACKREST COVER REMOVAL/INSTALLATION
1. Remove the rear seat backrest. See - See: Rear Seat Backrest - Split Bench Removal/Installation.
2. Remove the head restraint(s).
3. Remove the 2 screws and the latch cover.
4. Remove the 2 seat latch release cover screws.
5. Remove the seat latch release lever.
a. Detach the latch rod from the seat latch release lever.
i.
To aid installation, lock the latch using a flat-blade screwdriver before connecting the latch rod.
b. Remove the seat latch release lever.