Tribute 2WD L4-2.5L (2009)
1. Bend the retaining tab back on the pressure sensor component bracket.
Seat with an original equipment OCS system
1. Feed the OCS system components (pressure sensor and hose) through the opening in the seat cushion frame.
CAUTION:Failure to route the seat occupant classification sensor (OCS) components through the correct seat cushion support opening can cause
component failure.
CAUTION:While positioning the seat cushion frame and occupant classification sensor (OCS), be careful not to damage any of the components. Failure
to do so can result in component failure.
2. Align the OCS bladder to the seat cushion frame.
3. Install the 2 pin-type retainers to the OCS bladder and seat cushion frame.
4. Install the pressure sensor onto the seat cushion frame bracket, making sure the retaining tab is completely engaged.
-
When installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from its bracket without
disengaging the retaining tab.
NOTE:Make sure the pressure sensor hose is not kinked during installation.
5. Slide the OCSM into the seat cushion frame bracket and install the rivets.
-
The OCSM must be correctly positioned and securely fastened in place. Failure to do so can set a DTC in the restraints control module (RCM).
6. Position the foam pad to the seat cushion frame.
