Tribute 2WD L4-2.5L (2009)
Electronic Brake Control Module: Service and Repair
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE REMOVAL/INSTALLATION
WARNING:Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been
previously drained. Following this instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING:Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal
injury.
CAUTION:Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic
surface, immediately wash it with water.
NOTE:Do not swap ABS modules between vehicles, the ABS module and the hydraulic control unit (HCU) are calibrated as an assembly.
1. Remove the hydraulic control unit (HCU). See See: Hydraulic Control Assembly - Antilock Brakes/Service and Repair.
2. Remove the jumper tube assembly bracket nut.