Tribute 2WD L4-2.5L (2009)
Brake Pedal Assy: Service and Repair
BRAKE PEDAL AND BRACKET REMOVAL/INSTALLATION
1. Remove the brake pedal position (BPP) switch. See See: Antilock Brakes / Traction Control Systems/Braking Sensor/Switch/Service and Repair.
CAUTION:Do not service the brake pedal or brake booster without first removing the brake pedal position (BPP) switch and speed control deactivator
switch. These switches must be removed with the brake pedal in the at-rest position. Switch plungers must be compressed for the switch to rotate in the
bracket. Attempting to remove the switch when the plunger is extended (during pedal apply) will result in damage to the switch.
2. Remove and discard the booster push rod clevis locking pin.
NOTE:The booster push rod clevis locking pin is a one-time use only part. Anytime the booster push rod clevis locking pin is removed, a new booster
push rod clevis locking pin should be used.
NOTE:Remove the clevis locking pin by squeezing the locking tabs and pulling outward on the opposite end.
3. Disconnect the accelerator pedal electrical connector.
4. Remove the brake pedal bracket upper bolt.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
5. Remove the brake pedal bracket upper and lower nuts.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
6. Remove the 4 brake booster nuts.
-
To install, tighten to 23 Nm {2.3 kgf-m, 17 ft-lbf}.
7. Remove the brake pedal and bracket assembly.
